- About us
- Code of Conduct
- Google SoC
- Recent posts
- Security Workshops
Now the second step in tracking botnets takes place, we want to re-connect into the botnet. Since we have all the necessary data, this is not very
hard. In a first approach, you can just setup an irssi (console based IRC client) or some other IRC client and try to connect to the network. If the network is relatively small (less then 50 clients), there is a chance that your client will be identified since it does not answer to valid commands. In this case, the operators of the botnets tend to either ban and/or DDoS the suspicious client.
To avoid detection, you can try to hide yourself. Disabling all auto response triggering commands in your client helps a bit: If your client replies to a
"CTCP VERSION" message with "irssi 0.89 running on openbsd i368" then the attacker who requested the Client-To-Client Protocol (CTCP) command will get suspicious. If you are not noticed by the operators of the botnets, you can enable logging of all commands and thus observe what is happening.
But there are many problems if you start with this approach: Some botnets use very hard stripped down IRCds which are not RFC compliant so that a normal IRC client can not connect to this network. A possible way to circumvent this situation is to find out what the operator has stripped out, and modify the source code of your favorite client to override it. Almost all current IRC clients lack well written code or have some other disadvantages. So probably you end up writing your own IRC client to track botnets. Welcome to the club - ours is called drone. There are some pitfalls that you should consider when you write your own IRC client. Here are some features that we found useful in our dedicated botnet tracking IRC client:
Drone is capable of using SOCKS v4 proxies so we do not run into problems if it's presence is noticed by an attacker in a botnet. The SOCKS v4 proxies are on dial-in accounts in different networks so that we can easily change the IP addresses. Drone itself runs on a independent machine we maintain ourselves. We want to thank all the people contributing to our project by donating shells and/or proxies.
Some Anti-virus vendors publish data about botnets. While useful, this information may at times not be enough to to effectively track botnets, as we
demonstrate in Botnet Vendors.
Sometimes the owners of the botnet will issue some commands to instruct his bots. We present the more commonly used commands in the last section. Using our approach, we are able to monitor the issued commands and learn more about the motives of the attackers. To further enhance our methodology, we tried to write a PCRE-based emulation of a bot so that our dummy client could even correctly reply to a given command. But we soon minimized our design goals here because there is no standardization of botnet commands and the attackers tend to change their commands very often. In many cases, command-replies are even translated to their mother language.
When you monitor more than a couple of networks, begin to check if some of them are linked, and group them if possible. Link-checking is easy, just join a specific channel on all networks and see if you get more than one client there. It is surprising how many networks are linked. People tend to set up a DNS-name and channel for every bot version they check out. To learn more about the attacker, try putting the attacker's nickname into a Google search and often you will be surprised how much information you can find. Finally, check the server's Regional Internet Registries (RIR) entry (RIPE NCC, ARIN, APNIC, and LACNIC) to even learn more about the attacker.